Is your Lenovo ThinkPad T410s mouse not moving or frozen? You might want to replace your palm-rest, and this guide will help you replace it!

  1. Flip the laptop over.
    • Flip the laptop over.

    • Push and hold the locking switch to the left.

    • Pull the battery out with your other hand.

  2. Remove the single Phillips #0 screw grin the back panel.
    • Remove the single Phillips #0 screw grin the back panel.

    • Pull the back panel off.

    • Pull the metal prongs at the side of the RAM away from each other.

      • The RAM will pop out of its socket when done correctly.

    • Pull the RAM out.

    • Remove the Flathead 2.5mm screw.

    • Flip the laptop over.

    • Wedge the flat end of a spudger, or plastic opening tool, under the end of the keyboard and pry up.

    • Slide the keyboard out of the way until you can see what's underneath it.

    • The keyboard is still attached with a ribbon cable so don't try to fully remove it.

    • Use the flat end of a spudger to unplug the keyboard connector from the laptop.

    • Pull the keyboard out.

    • Remove the twelve Phillips #0 screws from the back panel.

    • Up the flat end of a spudger to lift up the black tab on the ZIF connector.

    • Pull out the ribbon connector from the ZIF connector.

    • Remove the palm rest from the laptop.


To reassemble your device, follow these instructions in reverse order.

Nathan Barganier

Member since: 21-02-2018

97 reputação

Autoria de 1 guia

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 14

Todo: 116