Introdução

This requires using a tool to help lift up the power switch board to slide it out of the slot. Be careful and go slow when removing it. Similarly, the tabs holding the ribbon cable down are very small.

Peças

Não são necessárias peças.

  1. Turn off the computer, unplug all cables, and let it cool down. Lay the computer flat on its screen.
    • Turn off the computer, unplug all cables, and let it cool down. Lay the computer flat on its screen.

    • Make sure that the work surface is flat and has nothing sharp on it.

  2. Remove the monitor stand screw in the bottom of the stand, and remove the stand completely. Remove the monitor stand screw in the bottom of the stand, and remove the stand completely.
    • Remove the monitor stand screw in the bottom of the stand, and remove the stand completely.

  3. Remove the two screws on the bottom of the computer, one on each side.
    • Remove the two screws on the bottom of the computer, one on each side.

  4. Locate the slot on the right side of the computer next to the screw hole. Use a plastic opening tool or spudger to pry off the rear cover. (Don’t be afraid to use a little force.) Locate the slot on the right side of the computer next to the screw hole. Use a plastic opening tool or spudger to pry off the rear cover. (Don’t be afraid to use a little force.) Locate the slot on the right side of the computer next to the screw hole. Use a plastic opening tool or spudger to pry off the rear cover. (Don’t be afraid to use a little force.)
    • Locate the slot on the right side of the computer next to the screw hole. Use a plastic opening tool or spudger to pry off the rear cover. (Don’t be afraid to use a little force.)

  5. Free shipping on all orders over US$100,00 or containing a Pro Tech Toolkit!

    Visite Nossa Loja
  6. Once it has been separated, lift to remove. Once it has been separated, lift to remove.
    • Once it has been separated, lift to remove.

  7. Remove the four screws that secure the arm stand. Remove the four screws that secure the arm stand.
    • Remove the four screws that secure the arm stand.

  8. Lift up to remove the arm stand. Lift up to remove the arm stand.
    • Lift up to remove the arm stand.

  9. Remove the 5 screws that secure the EMI cover. Remove the cover. Remove the cover.
    • Remove the 5 screws that secure the EMI cover.

    • Remove the cover.

  10. Locate the power switch board and the tan colored tab on it holding the blue and white ribbon cable down.
    • Locate the power switch board and the tan colored tab on it holding the blue and white ribbon cable down.

  11. Pull the tab towards the blue and white ribbon cable to open it. Pull the cable out of the power switch board.
    • Pull the tab towards the blue and white ribbon cable to open it. Pull the cable out of the power switch board.

  12. Slide the power switch cable out of its slot in the direction shown, making sure to lift up the end carefully. Slide the power switch cable out of its slot in the direction shown, making sure to lift up the end carefully.
    • Slide the power switch cable out of its slot in the direction shown, making sure to lift up the end carefully.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Jackson Blake

Member since: 22-01-2018

909 reputação

9 Guides authored

Equipe

Cal Poly, Team S16-G3, Banghart Winter 2018 Membro de Cal Poly, Team S16-G3, Banghart Winter 2018

CPSU-BANGHART-W18S16G3

4 Membros

9 Guides authored

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 5

Últimos 30 dias: 23

Todo: 198