Skip to main content

Introdução

First, check to see if the volume is turned up to a reasonable level by using both the volume rocker on the side of the device and the digital volume bar in the settings menu. If the troubleshooting has not solved the issue, the volume rocker will need to be replaced in a few simple steps. Minimal tools will be needed for this guide.

  1. Remove the two 3.5 mm Phillips #00 screws that are covered by the micro SD port.
    • Remove the two 3.5 mm Phillips #00 screws that are covered by the micro SD port.

    • This cover is adjacent to the volume button on the side of the Le Pan S.

  2. Insert the spudger between the front and back panel in order to pry them apart. Do this beside the volume button and the micro SD cover.
    • Insert the spudger between the front and back panel in order to pry them apart.

    • Do this beside the volume button and the micro SD cover.

    • Pry open the rest of the Le Pan S by dragging the spudger across the side.

  3. Kits de reparo de android

    A new screen or battery is one kit away.

    Comprar agora

    Kits de reparo de android

    A new screen or battery is one kit away.

    Comprar agora
  4. Once the front and back faces are completely separated, remove the back cover to reveal the inside components.
    • Once the front and back faces are completely separated, remove the back cover to reveal the inside components.

  5. Disconnect the battery from the circuitry and lay it out of the way. The best method to complete this is to pull the bundled cable connector out with your hands. Pull towards the wires and away from the electrical board. Use the spudger to further coax the cable out.
    • Disconnect the battery from the circuitry and lay it out of the way.

    • The best method to complete this is to pull the bundled cable connector out with your hands. Pull towards the wires and away from the electrical board. Use the spudger to further coax the cable out.

    • If you are replacing your battery, make sure to dispose of it properly.

  6. Remove the four 2.5 mm Phillips #00 head screws from the circuit board near the top of the tablet.
    • Remove the four 2.5 mm Phillips #00 head screws from the circuit board near the top of the tablet.

  7. Pull out the volume rocker by carefully moving it side to side with your fingers.
    • Pull out the volume rocker by carefully moving it side to side with your fingers.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Wiaam Elkhatib

Membro desde: 17-09-2015

175 Reputation

Autoria de 1 guia

Team

IUPUI, Team 2-1, Harley Fall 2015 Membro de IUPUI, Team 2-1, Harley Fall 2015

IUPUI-HARLEY-F15S2G1

5 Membros

10 Guias de autoria

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 166