Introdução

Steps to remove LG VX8550 screen

  1. Slide the battery release up.
    • Slide the battery release up.

    Adicionar comentário

  2. Remove the battery by lifting away from the case.
    • Remove the battery by lifting away from the case.

    Adicionar comentário

    • Remove the 2 screw covers next to the rear speaker with a Push Pin.

    Adicionar comentário

    • Remove the 4 cover screws with a Philips #00 screwdriver.

    Adicionar comentário

    • Use the iPod opening tool to pry off the back casing.

    Adicionar comentário

    • Continue sliding the iPod opening tool around the seam of the casing to separate the front and back casings.

    Adicionar comentário

    • Separate the casing halves.

    • Be sure to keep track of the side buttons as they fall out.

    Adicionar comentário

    • Remove the 2 screws from the back of the phone with a Phillips #00 Screwdriver.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Carefully lift up on the motherboard to see the ribbon cables underneath.

    • Use the spudger to carefully disconnect the ribbon cable from the motherboard.

    Adicionar comentário

    • Remove the motherboard from the front casing by lifting straight up.

    Adicionar comentário

    • Lay the phone with the screen facedown.

    • The 6 slider screws are visible.

    Adicionar comentário

    • Peel back but don't remove the blue tape to access the 2 center screws.

    • Remove the 6 slider screws with the Phillips #00 screwdriver.

    Adicionar comentário

    • Lift the keypad housing away from the slider.

    Adicionar comentário

    • Remove the 2 screw covers next to the speaker with a push pin next to the camera.

    Adicionar comentário

    • Remove the 6 screws with a Phillips #00 Screwdriver.

    Adicionar comentário

    • Use the ipod opening tool to pry the screen casing and the slider mechanism apart from each other.

    Adicionar comentário

    • Carefully lift the slider mechanism to see the ribbon cables underneath.

    Adicionar comentário

    • Slide ribbon cable through the slider mechanism.

    Adicionar comentário

    • Separate the two halves.

    Adicionar comentário

    • With the spudger, lift up under the connector to unplug it from the circuit board.

    Adicionar comentário

    • Lift and remove the blue tape from screen connector.

    Adicionar comentário

    • Lift the top edge of the screen using a pin to pry under the corner.

    Adicionar comentário

    • Grasp the ribbon cable near the connector and carefully slide it out of the white connector.

    • It is helpful to gently wiggle the ribbon cable from side to side.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Nathan Jones

Member since: 10-04-2010

83 reputação

10 Guides authored

Equipe

Cal Poly, Team 34-55, Forte Spring 2010 Membro de Cal Poly, Team 34-55, Forte Spring 2010

CPSU-FORTE-S10S34G55

5 Membros

20 Guides authored

What’s the process if I just need to replace the flex cable not the whole screen?

Roll Sumthin - Responder

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Todo: 3,755