Introdução

A guide to removing and reinstalling the flip phone's camera.

Turn the phone on its back.
  • Turn the phone on its back.

Adicionar comentário

Orient the phone as shown.
  • Orient the phone as shown.

  • Remove the battery cover by pushing upward with your thumb.

Adicionar comentário

  • Place your fingernail at the top of the battery and pry the battery out towards you.

Adicionar comentário

  • Flip the phone open.

  • Remove the four rubber plugs, located at the corners of the LCD screen, with a push-pin.

  • Use a Phillips #00 screwdriver to remove the four screws located underneath the rubber plugs.

Adicionar comentário

  • Insert the plastic opening tool in the seam of the top portion of the flip phone.

  • Gently pry the seam open.

  • Move the opening tool around the perimeter of the seam and gently take the front LCD face plate out.

Adicionar comentário

  • Close the flip phone.

  • Hold the base of the phone and gently remove the faceplate.

  • Place the phone and the faceplate on a clean, flat surface.

Adicionar comentário

  • Locate the phone camera.

  • Locate the white rubber stopper to left of the camera.

  • Remove white rubber stopper by grabbing an edge with your fingers and gently pulling it off.

Adicionar comentário

  • Lift the copper ribbon cable up from the bottom right hand corner.

Adicionar comentário

  • While holding the copper connection out of the way, use your fingernail to pry the camera out of its socket.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Douglas Blaalid

Member since: 13-01-2010

282 reputação

8 Guides authored

Equipe

Cal Poly, Team 4-13, Forte Winter 2010 Membro de Cal Poly, Team 4-13, Forte Winter 2010

CPSU-FORTE-W10S4G13

5 Membros

15 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 4

Todo: 2,060