Push the light gray rectangle in the top-center up.
  • Push the light gray rectangle in the top-center up.

  • While pushing up grab the sides of the battery and pull out.

Adicionar comentário

Unscrew the antenna by grasping the base and twisting counterclockwise.
  • Unscrew the antenna by grasping the base and twisting counterclockwise.

    • The antenna may separate from a black sleeve during removal. You may need to use tweezers to remove the sleeve. Remove both the antenna and the sleeve and set aside.

Adicionar comentário

  • The phone may have a rubber insert in the bottom of the phone (see picture). If this rubber insert exists, remove it from the bottom of phone and set aside.

Adicionar comentário

  • Using a Torx screwdriver with a T6-sized bit, unscrew the four screws on the back of the phone.

    • The bit size is engraved on the base of the bit head.

Adicionar comentário

  • With the phone flipped open, wedge the back cover from the faceplate by running the tip of the plastic opening tool around the seam on the back of the phone.

  • Gently pull the two pieces apart to separate.

    • Apply enough force to separate the pieces without cracking the back cover.

Adicionar comentário

  • Lift the computer chip to gain access to the keypad and side buttons beneath.

    • CAUTION: The computer chip is attached with a thin ribbon wire at upper right corner of case. DO NOT BREAK THE RIBBON WIRE.

Adicionar comentário

Conclusão

<b>To reassemble your device, follow these instructions in reverse order.</b>

Nico Chiarito

Member since: 21-01-2010

22 reputação

5 Guides authored

Equipe

Cal Poly, Team 8-47, Regan Winter 2010 Membro de Cal Poly, Team 8-47, Regan Winter 2010

CPSU-REGAN-W10S8G47

5 Membros

8 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Todo: 2,438