Introdução

This guide will help you replace the internal speaker found in the earpiece of the phone.

Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.
  • Make sure you remove the battery by lifting the tab on the back of the phone before opening the case.

  • Flip open the phone and locate the four screw covers.

Adicionar comentário

Remove all four screw covers by using an IPod opening tool. They should come off relatively easy.
  • Remove all four screw covers by using an IPod opening tool. They should come off relatively easy.

Adicionar comentário

Using a T6 Torx screwdriver, remove all four screws.
  • Using a T6 Torx screwdriver, remove all four screws.

Adicionar comentário

Once the screws are removed, use an IPod opening tool to separate the front cover from the inner screen cover. Run the Ipod opening tool down both sides,disconnecting the tabs that hold the covers together. Run the Ipod opening tool down both sides,disconnecting the tabs that hold the covers together.
  • Once the screws are removed, use an IPod opening tool to separate the front cover from the inner screen cover.

  • Run the Ipod opening tool down both sides,disconnecting the tabs that hold the covers together.

Adicionar comentário

Pull the inner screen cover towards you and up in order to separate it from the front cover. Pull the inner screen cover towards you and up in order to separate it from the front cover.
  • Pull the inner screen cover towards you and up in order to separate it from the front cover.

Adicionar comentário

Remove the tape from the bottom of the LCD screen.
  • Remove the tape from the bottom of the LCD screen.

Adicionar comentário

Carefully lift the LCD screen and peel it from the gold ribbon. The sticky connection runs all the way around the LCD screen. Carefully lift the LCD screen and peel it from the gold ribbon. The sticky connection runs all the way around the LCD screen. Carefully lift the LCD screen and peel it from the gold ribbon. The sticky connection runs all the way around the LCD screen.
  • Carefully lift the LCD screen and peel it from the gold ribbon. The sticky connection runs all the way around the LCD screen.

Adicionar comentário

Flip the screen over so that you can see the outer LCD screen and the circuit board. Insert spudger in the bottom right corner. Lift up and move the spudger across the bottom.
  • Flip the screen over so that you can see the outer LCD screen and the circuit board.

  • Insert spudger in the bottom right corner.

  • Lift up and move the spudger across the bottom.

  • The third photo is rotated 180 degrees.

Adicionar comentário

Use the pointy side of the spudger to peel off the interior tape. Flip the assembly over and peel the circuit board from the screen.
  • Use the pointy side of the spudger to peel off the interior tape.

  • Flip the assembly over and peel the circuit board from the screen.

Adicionar comentário

Use the spudger to remove the LCD screen from its backing. Use the spudger to remove the LCD screen from its backing.
  • Use the spudger to remove the LCD screen from its backing.

Adicionar comentário

Desolder the wires connecting the speaker.
  • Desolder the wires connecting the speaker.

  • Solder on wires from new speaker.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Joshua Herrmann

Member since: 16-04-2010

8 reputação

16 Guides authored

Equipe

Cal Poly, Team 6-14, Maness Spring 2010 Membro de Cal Poly, Team 6-14, Maness Spring 2010

CPSU-MANESS-S10S6G14

4 Membros

16 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 1,352