KidzLane Walkie-Talkie Press-to-speak button Replacement - Guia de Reparo iFixit

Introdução

You will need a small Phillips head screwdriver and a soldering device to complete this project.

O que você precisa

Passo 1 Press-to-speak button

KidzLane Walkie-Talkie Press-to-speak button Replacement, Press-to-speak button: passo 1, imagem 1 %32

Place the Walkie-Talkie on a flat surface-preferably a table or a desk.
Flip the device over to where you see four screws in each corner.
Make sure you take out the batteries before proceeding.

Passo 2

KidzLane Walkie-Talkie Press-to-speak button Replacement: passo 2, imagem 1 %32

KidzLane Walkie-Talkie Press-to-speak button Replacement: passo 2, imagem 2 %32

Using your Phillips head screwdriver, unscrew all four 4mm screws from each corner.

Passo 3

KidzLane Walkie-Talkie Press-to-speak button Replacement: passo 3, imagem 1 %32

Once you have unscrewed all four corners, open the device so it will be in two parts.
As you're opening the inside of the Walkie-Talkie, don't break off any wires within the device.
Taking the Phillips head screwdriver again, unscrew the three screws on the circuit board (green plate).
Separate these screws from the other four since they are different sizes.

Passo 4

KidzLane Walkie-Talkie Press-to-speak button Replacement: passo 4, imagem 1 %32

KidzLane Walkie-Talkie Press-to-speak button Replacement: passo 4, imagem 2 %32

Take the circuit board out of the plastic casing.
Use the soldering device to iron the silver box (press-to-speak button), and then remove it from the circuit board.

Linha de Chegada

2 outras pessoas executaram este guia.

Autor(a)

com 7 outros contribuidores

Amin

Membro desde: 02/13/16

642 Reputação

Autoria de 5 guias

+4 outros emblemas

Equipe

IUPUI, Team 1-1, Wilson Spring 2016 Membro de IUPUI, Team 1-1, Wilson Spring 2016

IUPUI-WILSON-S16S1G1

Membros da 4

Autoria de 5 guias

0 comentários

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 5

Duração total: 898