Introdução

The Insignia 2-in-1 Handheld/Stick vacuum can lose its ability to create suction. Use this guide to access the vacuum's motor for replacement and troubleshooting.

Peças

Não são necessárias peças.

  1. Push down the black button to release the dust cup.
    • Push down the black button to release the dust cup.

    • Pull the dust cup up and away from handheld portion to remove.

    Adicionar comentário

  2. Remove the five 12.0 mm screws on the back of the handheld portion using the Phillips #2 screwdriver.
    • Remove the five 12.0 mm screws on the back of the handheld portion using the Phillips #2 screwdriver.

    • Lift the silver cover off of the black body of the handheld portion to expose the battery and wiring.

    Adicionar comentário

    • Pull apart the red and black wires.

    • Do so for all of the wires. (Red x1, Black x2)

    Adicionar comentário

    • Remove the tape holding the battery to the black housing.

    • Slide the entire battery bundle out.

    Adicionar comentário

    • Use plastic spudger to remove blue wire from motor, freeing the motor.

    Adicionar comentário

    • Twist and pull black casing off of the motor, leaving the motor and irremovable black impeller housing.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Thibaut Pillot

Member since: 15-02-2018

428 reputação

5 Guides authored

Equipe

USF Tampa, Team S16-G3, Boczar Spring 2018 Membro de USF Tampa, Team S16-G3, Boczar Spring 2018

USFT-BOCZAR-S18S16G3

4 Membros

6 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Todo: 49