Introdução

This guide will show the required steps to replace the ice tray on the Insignia Ice Maker.

  1. Remove the 6 screws holding the rear casing on. Remove the rear casing Remove the rear casing
    • Remove the 6 screws holding the rear casing on.

    • Remove the rear casing

  2. Remove the 4 screws holding the Ice Tray to the body of the Ice Maker. Remove the 4 screws holding the Ice Tray to the body of the Ice Maker. Remove the 4 screws holding the Ice Tray to the body of the Ice Maker.
    • Remove the 4 screws holding the Ice Tray to the body of the Ice Maker.

  3. Free shipping on all orders over US$100 or containing a Pro Tech Toolkit!

    Visite Nossa Loja
  4. Remove the 4 screws holding the Ice Tray from the top. Remove the 4 screws holding the Ice Tray from the top. Remove the 4 screws holding the Ice Tray from the top.
    • Remove the 4 screws holding the Ice Tray from the top.

  5. Lift the Water Pump out of the way Lift the Water Pump out of the way
    • Lift the Water Pump out of the way

  6. Remove the final 2 screws. Remove the final 2 screws. Remove the final 2 screws.
    • Remove the final 2 screws.

  7. Remove the plastic cover from the circuit board by pressing the lever on the side. A pry tool may be required. Disconnect the water tray cord. Disconnect the water tray cord.
    • Remove the plastic cover from the circuit board by pressing the lever on the side. A pry tool may be required.

    • Disconnect the water tray cord.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Evan Taylor

Member since: 18-01-2018

544 reputação

5 Guides authored

Equipe

Cal Poly, Team S21-G3, Banghart Winter 2018 Membro de Cal Poly, Team S21-G3, Banghart Winter 2018

CPSU-BANGHART-W18S21G3

2 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 4

Todo: 137