Introdução

This guide will show the steps required to disassemble an Insignia Ice Maker and replace the fan inside. It should take approximately 5-10 minutes.

Ferramentas

Peças

Não são necessárias peças.

Undo the 6 Screws found on the bottom edge holding the rear casing on. Undo the 6 Screws found on the bottom edge holding the rear casing on.
  • Undo the 6 Screws found on the bottom edge holding the rear casing on.

Adicionar comentário

Pull the casing off.
  • Pull the casing off.

Adicionar comentário

Locate the fan on the side of the Ice maker and undo the 4 screws holding it in place. Locate the fan on the side of the Ice maker and undo the 4 screws holding it in place.
  • Locate the fan on the side of the Ice maker and undo the 4 screws holding it in place.

Adicionar comentário

Remove the cover from the circuit board by pressing against the lever to the side. A pry tool may be needed. Remove the cover from the circuit board by pressing against the lever to the side. A pry tool may be needed.
  • Remove the cover from the circuit board by pressing against the lever to the side. A pry tool may be needed.

Adicionar comentário

Follow the fan's power cable and unplug. You may have to cut a zip tie holding the cable in place. You may have to cut a zip tie holding the cable in place.
  • Follow the fan's power cable and unplug.

  • You may have to cut a zip tie holding the cable in place.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Evan Taylor

Member since: 18-01-2018

517 reputação

5 Guides authored

Equipe

Cal Poly, Team S21-G3, Banghart Winter 2018 Membro de Cal Poly, Team S21-G3, Banghart Winter 2018

CPSU-BANGHART-W18S21G3

2 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 4

Todo: 33