InFocus X2 Lamp Replacement

Introdução

The InFocus X2 projector’s lamp can become burned out, resulting in a picture that is blacked out on one side. This guide will describe how to access the lamp and replace the burned-out part with a new one.

O que você precisa

Passo 1 Open the Lamp Door

InFocus X2 Lamp Replacement, Open the Lamp Door: passo 1, imagem 1 %32

InFocus X2 Lamp Replacement, Open the Lamp Door: passo 1, imagem 2 %32

InFocus X2 Lamp Replacement, Open the Lamp Door: passo 1, imagem 3 %32

Be sure that the projector is turned off, unplugged, and has cooled for at least 30 seconds.
Insert the Jimmy into one of the two notches on the lamp door's top edge.
Then use light force on the Jimmy to pry the latch away from the door.
If necessary, insert the Jimmy into the second latch and separate it from the projector.
Remove the door away from the projector by hand.

Editar

Passo 2 Disconnect the Lamp

InFocus X2 Lamp Replacement, Disconnect the Lamp: passo 2, imagem 1 %32

InFocus X2 Lamp Replacement, Disconnect the Lamp: passo 2, imagem 2 %32

InFocus X2 Lamp Replacement, Disconnect the Lamp: passo 2, imagem 3 %32

Gently disconnect the lamp from the projector by using your thumb and forefinger to pinch on the white tab on the plug.
Then pull the plug away from the projector.

Editar

Passo 3 Unscrew the Lamp from the Projector

InFocus X2 Lamp Replacement, Unscrew the Lamp from the Projector: passo 3, imagem 1 %32

InFocus X2 Lamp Replacement, Unscrew the Lamp from the Projector: passo 3, imagem 2 %32

InFocus X2 Lamp Replacement, Unscrew the Lamp from the Projector: passo 3, imagem 3 %32

Use a Phillips #4 screwdriver or driver with the Phillips #4 head to unscrew the two 0.6 mm diameter brass screws from the lamp's housing.
For the lower screw, ensure it remains in the hole in the lamp assembly and it does not fall into the projector. If it falls in the projector, use a magnetized screw bit or a small magnet to pick it up and remove it.

Editar

Passo 4 Remove the Old Lamp

InFocus X2 Lamp Replacement, Remove the Old Lamp: passo 4, imagem 1 %32

Pull on the bottom plastic tab and remove the lamp by hand.

Editar

Passo 5 Insert the New Lamp

InFocus X2 Lamp Replacement, Insert the New Lamp: passo 5, imagem 1 %32

Insert the replacement lamp into the projector.

Editar

Conclusão

To reassemble your device, follow these instructions in reverse order.

Caution: The old bulb contains mercury. Please recycle it in a safe and appropriate manner. Look for your local recycling information at https://earth911.com/