Ir para o conteúdo principal

Huawei Mate 10 Pro Shields Replacement

Pré-requisito somente
Este guia destina-se apenas a ser usado como pré-requisito para outros guias. É incompleto por si só.

O que você precisa

  1. Huawei Mate 10 Pro Shields Replacement, Back Cover: passo 1, imagem 1 %32
    • Switch off your phone.

    • Prepare an iOpener and apply it to the back of the phone for about two minutes to loosen the adhesive beneath the back cover.

  2. Huawei Mate 10 Pro Shields Replacement: passo 2, imagem 1 %32 Huawei Mate 10 Pro Shields Replacement: passo 2, imagem 2 %32 Huawei Mate 10 Pro Shields Replacement: passo 2, imagem 3 %32
    • Lift up the back cover with a suction cup until you can insert the flat end of a halberd spudger.

    • Use the halberd spudger to cut the adhesive beneath the back cover on all sides of the phone.

    • Use opening picks to avoid the adhesive from sticking to the back cover again while cutting the adhesive on all sides.

  3. Huawei Mate 10 Pro Shields Replacement: passo 3, imagem 1 %32 Huawei Mate 10 Pro Shields Replacement: passo 3, imagem 2 %32
    • Don't remove the back cover all the way, yet. The fingerprint sensor cable is still connected to motherboard.

    • Flip the back cover over to the side.

    • Remove the Phillips #00 screw which holds down the metal shield, sitting on top of the connection of the fingerprint sensor cable.

  4. Huawei Mate 10 Pro Shields Replacement: passo 4, imagem 1 %32 Huawei Mate 10 Pro Shields Replacement: passo 4, imagem 2 %32
    • Use a pair tweezers to remove the metal shield covering the connector of the fingerprint sensor.

    • Disconnect the fingerprint sensor cable with a spudger.

    • When reassembling your phone apply new adhesive where it is necessary.

  5. Huawei Mate 10 Pro Shields Replacement, Shields: passo 5, imagem 1 %32 Huawei Mate 10 Pro Shields Replacement, Shields: passo 5, imagem 2 %32 Huawei Mate 10 Pro Shields Replacement, Shields: passo 5, imagem 3 %32
    • Remove the twelve Phillips #00 screws.

    • Carefully remove the shields on top of the motherboard and the charging board.

    • In case the shields do not pop out easily on their own after you removed the Phillips screws, you can use the pointed end of a spudger to pry them out.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Dominik Schnabelrauch

Membro desde: 11/23/16

201.069 Reputação

Autoria de 682 guias

Equipe

iFixit Membro de iFixit

Staff

Membros da 136

Autoria de 16.562 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Duração total: 21