Introdução

Sometimes a burning smell can come form the toaster. This could be caused by crumbs stuck in the unit so its suggested that you deep clean the Black and Decker Toast R Oven.

Peças

Não são necessárias peças.

Make sure that the toaster is unplugged before you begin.
  • Make sure that the toaster is unplugged before you begin.

  • Turn the toaster over with its backside face down.

  • Remove the two Phillips #4 1cm screws that attach the side panels.

Adicionar comentário

Pull downwards (towards the bottom of the unit) and outward to remove the side panels.
  • Pull downwards (towards the bottom of the unit) and outward to remove the side panels.

Adicionar comentário

  • Remove the metal vent piece that is below the door.

  • This should slide off easily once both of the side panels are removed.

Adicionar comentário

  • Remove the two Phillips #4 1 cm screws, which connect the bottom panel to the unit.

Adicionar comentário

  • Remove the crumb tray (the bottom, metal panel) from the toaster unit.

Adicionar comentário

  • Remove the aluminum strip from the bottom of unit; this is the piece that is directly under the door.

Adicionar comentário

  • Remove the knobs by pulling them upward; they should slide right off.

  • When placing the knobs back on the unit, make sure the semicircle notch fits correctly in the hole so that the knobs don't fall off.

Adicionar comentário

  • Unhook the bottom of the the display panel from the toaster unit.

  • It will be a little tough to pry off, but don't be afraid to be forceful. You can use your hands, or pliers, to bend the metal piece backwards.

Adicionar comentário

  • Begin to detach the back panel from the toaster unit.

  • Then, unhook the rest of the display panel.

  • This will also be a little tough to get off, but don't be afraid to be forceful.

Adicionar comentário

  • Now, you can clean the outside units of the toaster oven.

Adicionar comentário

  • Remove the the heating coil protection bar from the toaster unit by first pulling out the left side.

Adicionar comentário

  • Finish removing the outside cover by lifting the lid upward.

Adicionar comentário

  • Remove the four Phillips #4 1 cm screws from the back of the unit.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Jonathan

Member since: 18-09-2012

120 reputação

5 Guides authored

Equipe

Cal Poly, Team 2-10, Propen Fall 2012 Membro de Cal Poly, Team 2-10, Propen Fall 2012

CPSU-PROPEN-F12S2G10

4 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 3

Últimos 7 dias: 17

Últimos 30 dias: 113

Todo: 8,218