How to Replace a Tuning Key on a Sterling by Music Man StingRay Ray4HH Electric Bass

Introdução

If a faulty tuning machine on your Sterling by Music Man-StingRay Ray4HH Electric Bass is preventing you from tuning - it's time for a replacement.

This guide can be used to replace non-functioning tuning keys for your Sterling. Before starting the disassembly, make sure to acquire the correct tuning keys and type of string.

Steps 5 & 6 require the use of a drill- it is important to be aware of your environment and take caution.

O que você precisa

Passo 1 Tuning Key

How to Replace a Tuning Key on a Sterling by Music Man StingRay Ray4HH Electric Bass, Tuning Key: passo 1, imagem 1 %32

How to Replace a Tuning Key on a Sterling by Music Man StingRay Ray4HH Electric Bass, Tuning Key: passo 1, imagem 2 %32

How to Replace a Tuning Key on a Sterling by Music Man StingRay Ray4HH Electric Bass, Tuning Key: passo 1, imagem 3 %32

Turn the tuning key counter-clockwise to the loosen string.
Only loosen the turning key(s) that need to be replaced.
Continue turning until there is slack in the string.

Editar

Passo 2

Cut the desired string with needle nose pliers.
Make sure the string has slack before cutting.
Remove the string by threading out through the bottom of the bass.

Editar

Passo 3

Use a Phillips #1 screwdriver to remove the four 9.53 mm screws.
Remove the broken tuning key.

Editar

Passo 4

How to Replace a Tuning Key on a Sterling by Music Man StingRay Ray4HH Electric Bass: passo 4, imagem 3 %32

Adjust the direction of the replacement tuning key as need.
Line up the screw holes of the tuning key to the existing drill holes on the bass.

Editar

Passo 5

Note the length of the tuning key securing screws to estimate the drill depth needed to drill into the headstock.
Drill new placement holes into the headstock using a 1/16" drill bit.
Drill in a level environment and be aware of surroundings.
Drill the holes straight down and centered with the tuning key screw holes.

Editar

Passo 6

Secure the four 9.58 mm screws using a drill with the Phillips #2 screwdriver bit.
Make sure the drill is not held at an angle to prevent the screws from stripping.

Editar