Introdução

Fans on electronic devices collect a lot dust over the years, so this guide will show how to clean the fan on this Toshiba projector in order to prevent overheating. To ensure maximum performance out of a fan, some oil can be added to keep the bearings lubricated and running in tip-top shape.

Peças

Não são necessárias peças.

Remove the two screws from the bottom plate as shown. Remove the two screws from the bottom plate as shown.
  • Remove the two screws from the bottom plate as shown.

Adicionar comentário

Remove the two screws on the bulb housing.
  • Remove the two screws on the bulb housing.

Adicionar comentário

Pull the tab up and pull the bulb out vertically. Some force will be required, but it will come out.
  • Pull the tab up and pull the bulb out vertically. Some force will be required, but it will come out.

Change “tab” with “metal handle” or “wire handle”

lkmemphis - Responder

Using a can of compressed air, blow on the fan until all dust is gone.
  • Using a can of compressed air, blow on the fan until all dust is gone.

  • Oil can be added in with a dropper on the bearing if needed.

The bearing can be oiled with a dropper, if needed. [What kind of mechanical oil comes with a dropper? What kind of oil should be used?]

lkmemphis - Responder

The major image for cleaning the fan should have been a bit more of a longshot so that the canned air can (or enough of it) clearly shows. Then Step 4 is fine as a close up now that the fixer knows what that red tube is connected to.

lkmemphis - Responder

Conclusão

To reassemble your device, follow these instructions in reverse order.

Bryan Underwood

Member since: 02-04-2018

697 reputação

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 5

Todo: 34