Ir para o conteúdo principal
Participe da comunidade de reparos - Criar conta

Honda Accord Car Key Remote

O que você precisa

  1. Honda Accord Car Key Remote, Replacing the battery: passo 1, imagem 1 %32 Honda Accord Car Key Remote, Replacing the battery: passo 1, imagem 2 %32
    • Locate the screw in the middle of your car key.

    • Make sure you have the following tools - Tri-point Screwdriver - CR2032 Battery

  2. Honda Accord Car Key Remote: passo 2, imagem 1 %32
    • With your screwdriver, begin to screw in a counter-clockwise motion.

  3. Honda Accord Car Key Remote: passo 3, imagem 1 %32
    • Each key should have a small gap. Locate this gap on the side of your key.

    • After you have taken off the screw, place the small screw somewhere safe. Then with the same screwdriver or a flathead screwdriver, you want to apply pressure to the small gap to pop it open.

  4. Honda Accord Car Key Remote: passo 4, imagem 1 %32 Honda Accord Car Key Remote: passo 4, imagem 2 %32 Honda Accord Car Key Remote: passo 4, imagem 3 %32
    • This is an example of how the key should look after you pop it open.

  5. Honda Accord Car Key Remote: passo 5, imagem 1 %32
    • Do not touch the other half of the key

    • After popping open the key, the battery should be located on the left half of the key.

  6. Honda Accord Car Key Remote: passo 6, imagem 1 %32
    • Apply pressure with the flathead screwdriver, and the battery should pop out once again.

  7. Honda Accord Car Key Remote: passo 7, imagem 1 %32 Honda Accord Car Key Remote: passo 7, imagem 2 %32
    • swap the old battery with the new battery

    • Make sure the smooth part of the battery is facing inside and not facing outwards as shown on the picture

  8. Honda Accord Car Key Remote: passo 8, imagem 1 %32
    • Lastly, place the key back together and screw the middle part back with the tri-point screwdriver.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Emerson Corado

Membro desde: 12/07/22

157 Reputação

Autoria de 1 guia

1Comentário do guia

You listed the wrong battery. It uses a CR1620 not a CR2032. Your picture even shows the correct battery. Also I believe it is a P000 screwdriver, that is what fit my 2013 Accord key.

Mark Fox - Responder

Comentar

Visualizações:

Últimas 24 horas: 2

Últimos 7 dias: 5

Últimos 30 dias: 23

Ao todo: 556