1. Unplug the device from any energy sources.
    • Unplug the device from any energy sources.

    • Lift the top cover of the scanner.

    • Use a plastic prying tool to remove the plastic frame surrounding the glass.

    Adicionar comentário

  2. Carefully pull the frame away from the glass.
    • Carefully pull the frame away from the glass.

    • If it doesn't remove easily, use the iFixit Opening Tool again to pry stuck sections.

    Adicionar comentário

    • Use a T10 screwdriver to unscrew the two screws that fasten the frame to the printer hood.

    Adicionar comentário

    • Put your finger behind the panel with the power button.

    • Then, pull the piece outwards.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Unscrew the screw inside the power button panel space.

      • Then, unscrew the screw that is across the printer slider.

    Adicionar comentário

    • Pull the white circuit board outwards which is located under the small screen.

    • Unplug the small ribbon cable from the circuit board.

    • Be careful when you unplug the ribbon cable not to use too much force. Using too much force may damage or rip the cable.

    Adicionar comentário

    • Unplug the small ribbon cable from the circuit board. Be careful when you unplug the ribbon cable not to use too much force. Using too much force may damage or rip the cable.

    Adicionar comentário

    • Pull the memory card reader's circuit board out.

    • Detach the white wiring connector from the back of the circuit board.

    • You may need to use a finger nail or a Plastic Prying Tool to detach the white wiring connector from the circuit board.

    Adicionar comentário

    • Put your finger behind the small screen.

    • Then, pull it up.

    • Do not hesitate to use force to remove the TouchSmart panel.

    • Disconnect the ribbon cable from the small screen.

    Adicionar comentário

    • Pull the printer hood upward.

    Adicionar comentário

    • Lift the scanning lid from the lower portion of the printer hood.

    Remove torx screw on bottom of assembly in corner near touchsmart screen space.

    Jeff - Responder

    • Leaving the ribbon connected, lift the sliding scanner off the track.

    • Pull the ribbon cable out of the slot on the scanner circuit board.

    • Insert the scanning piece into the rolling track.

    Adicionar comentário

Conclusão

To reassemble the sliding scan piece, follow these instructions in reverse order.

Renee Lamb

Member since: 26-09-2012

226 reputação

3 Guides authored

Equipe

Cal Poly, Team 2-11, Propen Fall 2012 Membro de Cal Poly, Team 2-11, Propen Fall 2012

CPSU-PROPEN-F12S2G11

4 Membros

6 Guides authored

Where can i buy the scaning piece? Im from Spain.

Bogdan Cosmin - Responder

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 7

Todo: 1,240