Ir para o conteúdo principal

Conserte seus objetos

Direito de executar reparos

Peças e ferramentas

Introdução

Make sure device is powered off and unplugged from any power source.

Peças

Nenhum componente especificado.

  1. Power off  device.
    • Power off device.

    • Flip laptop over.

  2. Remove the rubber foot with a Metal spudger Remove 5 Phillip 2.4 x 5.7mm screws using a PH0 Phillips head screwdriver.
    • Remove the rubber foot with a Metal spudger

    • Remove 5 Phillip 2.4 x 5.7mm screws using a PH0 Phillips head screwdriver.

    • Remove 5 Phillips 2.8 x 5.0mm screws using a PH0 Phillips head screwdriver.

  3. Telas LCD de reposição iPhone (com ferramentas)

    A opção econômica, coberta por nossa garantia vitalícia.

    Confira os kits

    Telas LCD de reposição iPhone (com ferramentas)

    Reduza os custos de reparo, não a qualidade.

    Confira os kits
  4. Open computer and pry open keyboard panel using the Metal Spudger. Apply little pressure then increase until keyboard pops away from motherboard. Gently lift keyboard on the mouse pad side. Remove three connected ribbon wires connecting keyboard to frame by gently disconnecting them from the motherboard. Gently lift keyboard on the mouse pad side. Remove three connected ribbon wires connecting keyboard to frame by gently disconnecting them from the motherboard.
    • Open computer and pry open keyboard panel using the Metal Spudger. Apply little pressure then increase until keyboard pops away from motherboard.

    • Gently lift keyboard on the mouse pad side. Remove three connected ribbon wires connecting keyboard to frame by gently disconnecting them from the motherboard.

  5. Remove eleven 2.0  x 4.6mm screws using the Phillips 00 Screwdriver
    • Remove eleven 2.0 x 4.6mm screws using the Phillips 00 Screwdriver

  6. Remove the motherboard gently from the base of the laptop. Disconnect the fastened cables from the motherboard by carefully pushing the cable's plastic edges using the metal Spudger. Disconnect the fastened cables from the motherboard by carefully pushing the cable's plastic edges using the metal Spudger.
    • Remove the motherboard gently from the base of the laptop.

    • Disconnect the fastened cables from the motherboard by carefully pushing the cable's plastic edges using the metal Spudger.

  7. Using the Phillips 00 Screw Driver. remove 4 screws from the heat sink. Remove any adhesive tape. Detach the fan/heat sink.
    • Using the Phillips 00 Screw Driver. remove 4 screws from the heat sink.

    • Remove any adhesive tape. Detach the fan/heat sink.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Meaghan Hyatt

Membro desde: 17-01-2019

277 Reputação

2 Guias de autoria

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 7

Últimos 30 dias: 18

Duração total: 163