Introdução

Unlike other laptops and computers, the trackpad is a part of the keyboard so it can't really be replaced without replacing the entire keyboard. A much simpler solution that we show in this guide requires the removal and replacement of a small ribbon-like connector.

Slide pill shaped tab to the other side of the channel.
  • Slide pill shaped tab to the other side of the channel.

Adicionar comentário

  • Remove battery while keeping the tab to the side.

Adicionar comentário

  • Unscrew the two screws JIS #0 located on opposites sides of the panel.

  • Screws are attached to the panel and will not fully come out.

Adicionar comentário

  • Carefully pry off the L-shaped panel.

Adicionar comentário

  • Pull out and unplug the tab on the right hand side.

Adicionar comentário

  • Unscrew all nine 6.0mm JIS #0 screws located on the border of the back panel.

Adicionar comentário

  • Remove 3 screws located where the battery previously was.

Adicionar comentário

  • Remove 6 screws located under the spot where the smaller L-shaped panel was located.

Adicionar comentário

  • Slowly pry off the keyboard from the back panel.

  • Between the back panel and the keyboard there are two ribbon wires.

  • Remove slowly to not break the back panel. If it does not come off easily, check to see if all screws are removed.

Adicionar comentário

  • Unplug wires connecting back panel to keyboard.

Adicionar comentário

  • Actual trackpad does not come out since it is a part of the whole keyboard.

  • Locate loosely attached blue strip at the bottom of the computer.

  • Locate the left ribbon strip attached to small black and white box.

  • Flip up the black tab while pulling out the ribbon.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Robert Hamilton

Member since: 01-03-2018

1.051 reputação

10 Guides authored

Equipe

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Todo: 35