Introdução

The speakers are relatively easy to remove. There are no screws. All you need to do is disconnect a wire and pull.

  1. Slide pill shaped tab to the other side of the channel.
    • Slide pill shaped tab to the other side of the channel.

    Adicionar comentário

    • Remove battery while keeping the tab to the side.

    Adicionar comentário

    • Unscrew the two screws JIS #0 located on opposites sides of the panel.

    • Screws are attached to the panel and will not fully come out.

    Adicionar comentário

    • Carefully pry off the L-shaped panel.

    Adicionar comentário

    • Pull out and unplug the tab on the right hand side.

    Adicionar comentário

    • Unscrew all nine 6.0mm JIS #0 screws located on the border of the back panel.

    Adicionar comentário

    • Remove 3 screws located where the battery previously was.

    Adicionar comentário

    • Remove 6 screws located under the spot where the smaller L-shaped panel was located.

    Adicionar comentário

    • Slowly pry off the keyboard from the back panel.

    • Between the back panel and the keyboard there are two ribbon wires.

    • Remove slowly to not break the back panel. If it does not come off easily, check to see if all screws are removed.

    Adicionar comentário

    • Unplug wires connecting back panel to keyboard.

    Adicionar comentário

    • Unplug the red and white wires.

    Adicionar comentário

    • Remove the speakers.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Robert Hamilton

Member since: 01-03-2018

1.051 reputação

10 Guides authored

Equipe

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 3

Todo: 44