Introdução

Replace the wireless card in your HP Pavilion dv6000.

Lay the laptop on a flat surface, battery side up.
  • Lay the laptop on a flat surface, battery side up.

  • Remove the two screws securing the RAM shield to the lower case.

  • The screws will remain captive within the shield.

  • Lift and remove the RAM shield up from the lower case.

Adicionar comentário

Use a pair of tweezers to disconnect both antennas from their sockets on the wireless card. Be careful to pull on the contacts and not the wires. The crimps used to hold them to the wires are delicate.
  • Use a pair of tweezers to disconnect both antennas from their sockets on the wireless card.

  • Be careful to pull on the contacts and not the wires. The crimps used to hold them to the wires are delicate.

Adicionar comentário

Remove the two 3.7 mm Phillips screws securing the wireless card to the motherboard.
  • Remove the two 3.7 mm Phillips screws securing the wireless card to the motherboard.

  • Upon removing the Phillips screws that secures the wireless card to the motherboard, the wireless card board should pop up from its top side.

  • Grasp the wireless card and pull it straight out of its socket on the motherboard.

Adicionar comentário

Wireless card remains.
  • Wireless card remains.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

4 outras pessoas concluíram este guia.

Ben Hirsch

Member since: 05-10-2010

3.577 reputação

10 Guides authored

Equipe

Cal Poly, Team 21-33, Regan Fall 2010 Membro de Cal Poly, Team 21-33, Regan Fall 2010

CPSU-REGAN-F10S21G33

4 Membros

10 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 7

Últimos 30 dias: 76

Todo: 24,725