Ir para o conteúdo principal

Introdução

HP Pavilion Wave comes with a pair of built-in mouse and keyboard. This guide shows you how to replace them without using any additional USB-port for your mouse and keyboard.

  1. Turn over computer and remove the rubber feet. Remove the 8mm Philips screws indicated by red circles with a Philips #0 screwdriver.
    • Turn over computer and remove the rubber feet.

    • Remove the 8mm Philips screws indicated by red circles with a Philips #0 screwdriver.

    • Use a pry tool and lift up on the lid.

  2. From back IO panel pry open the casing as indicated. From back IO panel pry open the casing as indicated.
    • From back IO panel pry open the casing as indicated.

  3. Finally Remove the two cables circled in red for the front IO panel. Finally Remove the two cables circled in red for the front IO panel.
    • Finally Remove the two cables circled in red for the front IO panel.

  4. Locate a blue USB adapter on the left side of the hard disk compartment.
    • Locate a blue USB adapter on the left side of the hard disk compartment.

  5. Take off the USB with gentle but firm pressure. This is a single USB adapter for both mouse and keyboard, so you must get a wireless mouse and keyboard pair, or you will have to use the extra USB for the other one.
    • Take off the USB with gentle but firm pressure.

    • This is a single USB adapter for both mouse and keyboard, so you must get a wireless mouse and keyboard pair, or you will have to use the extra USB for the other one.

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Kyaw Soe

Membro desde: 27-09-2017

261 Reputation

2 Guias de autoria

Team

Cal Poly, Team S8-G4, Banghart Fall 2017 Membro de Cal Poly, Team S8-G4, Banghart Fall 2017

CPSU-BANGHART-F17S8G4

4 Membros

5 Guias de autoria

Seems like there might be enough room for a usb 2 port hub/splitter (such as Onvian USB Splitter Cable Male to 2 Female Adapter USB) to add an additional usb dongle (such an RF or Insteon USB)? Can you confirm how much room there are?

thomastranrx - Responder

Since it's a year old project, I forgot most of the dimensions, but from my memory, it would be possible since it's located in a little groove that can probably fit a wire or two. (You can see it in step one picture)

Kyaw Soe - Responder

Add Comment

View Statistics:

Past 24 Hours: 9

Past 7 Days: 17

Past 30 Days: 43

All Time: 1,118