Introdução

The motherboard is the main circuit board found in a laptop. It manages the communication between crucial electronic components that allow your computer to function. This guide will describe how to remove and replace the motherboard for HP Envy x360m6-aq005dx

  1. Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.
    • Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.

    Adicionar comentário

  2. Use a Torx T5 head to remove the six 5.1 mm screws.
    • Use a Torx T5 head to remove the six 5.1 mm screws.

    • Use a JIS J1 to remove the two 7.2mm screws.

    Adicionar comentário

    • Use Plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.

    Adicionar comentário

    • Use a J1 to remove the six 4.7 mm screws.

    Adicionar comentário

    • Battery might cause a small electric shock.

    • Use tweezers to disconnect the battery from the motherboard.

    Adicionar comentário

    • Battery may cause a small electric shock

    • Use tweezers to disconnect the battery from the motherboard.

    Adicionar comentário

    • Use the Plastic opening tool to disconnect the power cable from the fan

    Adicionar comentário

    • Use your fingers to lightly pull the cable and disconnect it from the motherboard.

    Adicionar comentário

    • Use a PH0 tool bit to loosen the four 6.5 mm screws.

      • Do not fully remove the screws, just enough to be unattached from the motherboard.

    • Use a JIS J1 bit to remove the two 7.7 mm screws.

    Adicionar comentário

    • Use a J1 to remove the 4.7mm screws from the indicated positions

    • Use the J1 to remove 7.7mm screws from the indicated positions

    • Use the J1 to remove the 4.4mm screws from the indicated positions

    Adicionar comentário

    • Using your hand, lift the screen hinge located in the top left corner. This will allow for easier removal of the motherboard.

    Adicionar comentário

    • Flip the indicated colored latches with iFixit Opening Tools, then pull to release the cables attached to the motherboard.

    Adicionar comentário

    • Using your hand, lift and pull the motherboard from inside your computer

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Matthew Martin

Member since: 10-10-2017

501 reputação

5 Guides authored

Equipe

USF Tampa, Team S13-G17, Cagle Fall 2017 Membro de USF Tampa, Team S13-G17, Cagle Fall 2017

USFT-CAGLE-F17S13G17

4 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 3

Últimos 7 dias: 90

Últimos 30 dias: 336

Todo: 2,795