Pular para o conteúdo principal

Introdução

The fan is the main source of cooling for the laptop. It is the component that keeps your device from overheating, and can be the main source of noise from the laptop. This guide will show the proper removal of the laptop's hard drive.

  1. Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top. Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.
    • Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.

  2. Use a Torx T5 screwdriver to remove the six 5.1 mm screws. Use a JIS #1 screwdriver to remove the two 7.2mm screws. Use a JIS #1 screwdriver to remove the two 7.2mm screws.
    • Use a Torx T5 screwdriver to remove the six 5.1 mm screws.

    • Use a JIS #1 screwdriver to remove the two 7.2mm screws.

  3. Use a plastic opening tool to pry open the case. Go slowly around the edge.  You will hear popping noises, such are due to popping open the small joints that keep the cover attached.
    • Use a plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.

  4. Kit de Reparo de Bateria do MacBook

    A partir de $69.99

    Buy Now

    Kit de Reparo de Bateria do MacBook

    A partir de $69.99

    Buy Now
  5. Use a JIS #1 screwdriver to remove the six 4.7 mm screws. Use a JIS #1 screwdriver to remove the six 4.7 mm screws.
    • Use a JIS #1 screwdriver to remove the six 4.7 mm screws.

  6. Battery might cause a small electric shock.
    • Battery might cause a small electric shock.

    • Use tweezers to disconnect the battery from the motherboard.

  7. Use the plastic opening tool to disconnect the power cable from the  fan.
    • Use the plastic opening tool to disconnect the power cable from the fan.

  8. Use your fingers to lightly pull the cable and disconnect it from the motherboard. Use your fingers to lightly pull the cable and disconnect it from the motherboard.
    • Use your fingers to lightly pull the cable and disconnect it from the motherboard.

  9. Use a Phillips #0 screwdriver to loosen the four 6.5 mm screws. Do not fully remove the screws, just enough to be unattached from the  motherboard. Use a JIS #1 screwdriver to remove the two 7.7 mm screws.
    • Use a Phillips #0 screwdriver to loosen the four 6.5 mm screws.

    • Do not fully remove the screws, just enough to be unattached from the motherboard.

    • Use a JIS #1 screwdriver to remove the two 7.7 mm screws.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Matthew Martin

Membro desde: 10-10-2017

549 reputação

5 Guias de autoria

Equipe

USF Tampa, Team S13-G17, Cagle Fall 2017 Membro de USF Tampa, Team S13-G17, Cagle Fall 2017

USFT-CAGLE-F17S13G17

4 Membros

7 Guias de autoria

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 6

Últimos 30 dias: 27

Todo: 577