Introdução

The where you connect sound devices to the laptop. The USB is the main way to connect new devices to the laptop i.e. flash drive or mouse. This guide will show the proper removal of the laptop's USB port and audio jack.

Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top. Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.
  • Use the plastic opening tool to remove the gray rubber pads on the bottom of the laptop. For our device we only needed to remove the two at the top.

Adicionar comentário

Use a Torx T5 head to remove the six 5.1 mm screws. Use a JIS J1 to remove the two 7.2mm screws. Use a JIS J1 to remove the two 7.2mm screws.
  • Use a Torx T5 head to remove the six 5.1 mm screws.

  • Use a JIS J1 to remove the two 7.2mm screws.

Adicionar comentário

Use Plastic opening tool to pry open the case. Go slowly around the edge.  You will hear popping noises, such are due to popping open the small joints that keep the cover attached.
  • Use Plastic opening tool to pry open the case. Go slowly around the edge. You will hear popping noises, such are due to popping open the small joints that keep the cover attached.

Adicionar comentário

Battery might cause a small electric shock.
  • Battery might cause a small electric shock.

  • Use tweezers to disconnect the battery from the motherboard.

Adicionar comentário

Our pictures show the fan removed from the laptop. You do not need to remove the fan for this guide. Use a PH0 bit to remove the three 4.7 mm screws.
  • Our pictures show the fan removed from the laptop. You do not need to remove the fan for this guide.

  • Use a PH0 bit to remove the three 4.7 mm screws.

Adicionar comentário

Use the plastic opening tool to open the security connector. then pull the ribbon cable to disconnect it from the motherboard. Use the plastic opening tool to open the security connector. then pull the ribbon cable to disconnect it from the motherboard.
  • Use the plastic opening tool to open the security connector. then pull the ribbon cable to disconnect it from the motherboard.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Matthew Martin

Member since: 10-10-2017

501 reputação

5 Guides authored

Equipe

USF Tampa, Team S13-G17, Cagle Fall 2017 Membro de USF Tampa, Team S13-G17, Cagle Fall 2017

USFT-CAGLE-F17S13G17

4 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 9

Todo: 44