Ir para o conteúdo principal

Introdução

Prerequisite Only

Peças

Nenhum componente especificado.

  1. Press locking latch on the bottom of the base of the stand. Pull the plastic cover off of the stand.
    • Press locking latch on the bottom of the base of the stand.

    • Pull the plastic cover off of the stand.

  2. Use a Torx T15 driver and stick it through the holes on the stand in order to remove the two 12mm screws on the back of the main unit. Tilt stand and lift up to remove it.
    • Use a Torx T15 driver and stick it through the holes on the stand in order to remove the two 12mm screws on the back of the main unit.

    • Tilt stand and lift up to remove it.

  3. Use a Torx T15 driver to remove the single 10mm screw on the back panel. Pull the back panel toward the bottom of the device to remove it.
    • Use a Torx T15 driver to remove the single 10mm screw on the back panel.

    • Pull the back panel toward the bottom of the device to remove it.

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Michael Ewing

Membro desde: 01/10/2015

980 Reputação

4 Guias de autoria

Equipe

Cal Poly, Team 1-24, Maness Fall 2015 Membro de Cal Poly, Team 1-24, Maness Fall 2015

CPSU-MANESS-F15S1G24

4 Membros

14 Guias de autoria

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 8

Últimos 30 dias: 32

Duração total: 2,379