Introdução

Use this guide to replace and / or adjust the screen of the HP Elite x2 G1.

Peças

Não são necessárias peças.

With the screen face down, lift up the stand as far as it goes.
  • With the screen face down, lift up the stand as far as it goes.

  • Make sure not to force it past the resting point.

Adicionar comentário

Use a screwdriver to remove the six screws on the back of the tablet. (The screws were not in our device, so we do not know what kind of screwdriver to use.)
  • Use a screwdriver to remove the six screws on the back of the tablet.

  • (The screws were not in our device, so we do not know what kind of screwdriver to use.)

Adicionar comentário

After removing the screws, delicately close the stand.
  • After removing the screws, delicately close the stand.

  • Flip the tablet on its back so that the screen is facing up.

Adicionar comentário

Use the suction cup to carefully separate the screen from the device. Pull upwards with a fluid and smooth motion. Do not lift too fast! There will still be wires connecting the screen to the device. Make sure they are not tampered with.
  • Use the suction cup to carefully separate the screen from the device. Pull upwards with a fluid and smooth motion.

  • Do not lift too fast! There will still be wires connecting the screen to the device. Make sure they are not tampered with.

Adicionar comentário

Remove the tape on the lower left side of the screen. Underneath the tape, disconnect the LCM cable, the larger wire that was underneath the tape, from the back of the tablet screen. Underneath the tape, disconnect the LCM cable, the larger wire that was underneath the tape, from the back of the tablet screen.
  • Remove the tape on the lower left side of the screen.

  • Underneath the tape, disconnect the LCM cable, the larger wire that was underneath the tape, from the back of the tablet screen.

Adicionar comentário

Disconnect the flex cable from the device using the spudger. Remove the Display Assembly from the device.
  • Disconnect the flex cable from the device using the spudger.

  • Remove the Display Assembly from the device.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Colin Mika

Member since: 19-04-2018

773 reputação

6 Guides authored

Equipe

Cal Poly, Team S24-G7, Maness Spring 2018 Membro de Cal Poly, Team S24-G7, Maness Spring 2018

CPSU-MANESS-S18S24G7

4 Membros

6 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 4

Últimos 30 dias: 20

Todo: 77