Introdução

This guide explains how to remove the Motherboard from the HP 15-f009wm notebook computer. This could be done to either replace a malfunctioning Motherboard or to upgrade to a stronger Motherboard.

Turn laptop upside down.
  • Turn laptop upside down.

  • Flip the lock switch to the unlocked setting.

Adicionar comentário

Flip the release switch.
  • Flip the release switch.

  • Once the flip is switched, the battery should pop out.

Adicionar comentário

  • Slide the battery out.

Adicionar comentário

  • Remove the two Phillips #1 screws from the RAM panel.

Adicionar comentário

  • Use the plastic opening tool to pop the panel off.

Adicionar comentário

  • Release the tabs on each side of the chip by simultaneously pushing each tab away from the RAM.

  • These tabs lock the chip in place and releasing them will cause the chip to "pop" up.

Adicionar comentário

  • Remove the RAM chip from the laptop.

Adicionar comentário

  • Remove the sixteen 7mm Phillips #1 screws from the bottom panel.

Adicionar comentário

  • Pull the disk drive out of the laptop.

Adicionar comentário

  • Remove the three 2mm Phillips #00 screws found underneath the disk drive.

Adicionar comentário

  • Remove the single 4mm Phillips #1 screw from the Wi-Fi card.

  • Pull the Wi-Fi card out of the motherboard.

Adicionar comentário

  • Open the laptop.

  • Use a plastic opening tool to pop out the keyboard by starting at the top and working your way around the perimeter.

Adicionar comentário

  • Open the screen up until it lays flat and rotate the laptop until the screen is closest to you.

  • Lift the keyboard from the laptop.

  • Use a spudger to lift up the black latch on the ZIF connector and remove the ribbon cable.

Adicionar comentário

  • Remove the five 7mm Phillips #1 screws found underneath the keyboard.

Adicionar comentário

  • Use a spudger to lift the black tabs on the ZIF connectors.

  • Remove the ribbon cables from the ZIF connectors.

Adicionar comentário

  • Use a plastic opening tool to pop the palm rest off of the laptop.

  • Lift and remove the palm rest.

Adicionar comentário

  • Use a spudger to lift up the black latch on the ZIF connector.

  • Remove the USB/AUX port ribbon cable from the ZIF connector on the motherboard.

Adicionar comentário

  • Remove the single 7mm Phillips #1 screw from the USB/AUX board.

  • Remove the USB/AUX board from the laptop.

Adicionar comentário

  • Lift the Hard Drive from the laptop.

  • Disconnect the hard drive from the motherboard.

Adicionar comentário

  • Remove the four 4mm Phillips #1 screws from the motherboard.

  • Lift the motherboard up from the computer.

    • There will be three wires connected underneath.

Adicionar comentário

  • Disconnect the speaker.

Adicionar comentário

  • Remove the display connection wire. Lift the connection straight up from the motherboard.

Adicionar comentário

  • Flip the motherboard over.

  • Disconnect the charging port wire from the motherboard.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Alex Birchler

Member since: 14-02-2018

733 reputação

5 Guides authored

Equipe

USF Tampa, Team S2-G2, Nance Spring 2018 Membro de USF Tampa, Team S2-G2, Nance Spring 2018

USFT-NANCE-S18S2G2

4 Membros

5 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 2

Últimos 30 dias: 18

Todo: 86