Introdução

Adjusting the governor helps maintain a steady engine speed no matter the terrain and other conditions that could effect the engine workload. While the manufacturer highly recommends against this, it may be necessary to keep your engine running well.

Peças

Não são necessárias peças.

  1. Before starting, make sure the engine isn't running and is not hot. Using needle-nose pliers, carefully unhook the spring from the end opposite the air filter. Using needle-nose pliers, carefully unhook the spring from the end opposite the air filter.
    • Before starting, make sure the engine isn't running and is not hot.

    • Using needle-nose pliers, carefully unhook the spring from the end opposite the air filter.

  2. Free shipping on all orders over US$100,00 or containing a Pro Tech Toolkit!

    Visite Nossa Loja
  3. Use the needle-nose pliers to either lengthen or shorten the hook at the end of the spring.
    • Use the needle-nose pliers to either lengthen or shorten the hook at the end of the spring.

    • If your engine is stalling or refusing to start, try shortening the spring. This will enable more fuel to reach to engine at idle. If the engine is bogged down when running and you hear liquids splashing, try lengthening the spring.

  4. Carefully re-hook the spring on the arm it was disconnected from.
    • Carefully re-hook the spring on the arm it was disconnected from.

Conclusão

To reassemble your device, follow these instructions in reverse order.

Aaron Correya

Member since: 19-04-2018

227 reputação

2 Guides authored

Equipe

Cal Poly, Team S25-G15, Maness Spring 2018 Membro de Cal Poly, Team S25-G15, Maness Spring 2018

CPSU-MANESS-S18S25G15

4 Membros

7 Guides authored

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 8

Todo: 95