Introdução

More Random Access Memory (RAM) allows the laptop to run more programs simultaneously, and speed up certain processes. The Gateway MA 7 takes PC2-4200 DDR2 533Mhz 200PIN SODIMM RAM.

Ferramentas

Não são necessárias ferramentas.

  1. To prevent injury, make sure the laptop is unplugged before removing the battery.
    • To prevent injury, make sure the laptop is unplugged before removing the battery.

    • Push the locking tab over to the right away from the battery to unlock it from the laptop.

    • Hold the additional locking tab to the left while pulling out the battery.

    Adicionar comentário

  2. Remove the following screws securing the plastic panel from the bottom of the laptop:
    • Remove the following screws securing the plastic panel from the bottom of the laptop:

      • Seven 6 mm Phillips #0

    Adicionar comentário

    • Pull upwards on the top of the plastic panel to remove it.

    • With the exception of the screw marked "K", all of the screws will remain connected to the plastic piece.

    Adicionar comentário

    • Push the two metal tabs (holding the module in place) apart in order to release it.

    Adicionar comentário

    • Pull the ram out of the motherboard at a 45 degree angle.

    Adicionar comentário

    • Repeat steps 4 & 5 for the other memory module.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Tim Rose

Member since: 05-03-2018

365 reputação

2 Guides authored

Equipe

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 3

Últimos 7 dias: 6

Últimos 30 dias: 13

Todo: 86