Introdução

Removing the logic board from the Garmin Nuvi 200

Peel off the sticker from the bottom of the device to reveal two screws.
  • Peel off the sticker from the bottom of the device to reveal two screws.

Adicionar comentário

Remove two T5 Torx screws.
  • Remove two T5 Torx screws.

Adicionar comentário

  • Insert a plastic opening tool in the gap between the front and rear casing.

  • Carefully work the tool around the gap, separating the two halves of the case.

    • Keep the power switch in place while removing the rear case.

Adicionar comentário

  • Peel away the tape holding the ribbon cable in place.

  • Disconnect the ribbon cable by using a spudger to flip up the retaining flap on its ZIF-style connector. Then gently remove the cable.

Adicionar comentário

  • Pull out the cable between the logic board and the speaker to disconnect them.

Adicionar comentário

  • Remove the three screws from the logic board using the #00 Phillips screwdriver.

  • Lift the board away from the case but do not pull the logic board completely off, as it is still attached to the battery by a cable.

Adicionar comentário

  • Detach the logic board form the battery by pulling out the cable.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Anjelica

Member since: 11-04-2010

504 reputação

3 Guides authored

Equipe

Cal Poly, Team 25-90, Amido Spring 2010 Membro de Cal Poly, Team 25-90, Amido Spring 2010

CPSU-AMIDO-S10S25G90

4 Membros

9 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 3

Últimos 30 dias: 12

Todo: 9,576