Introdução

The lens filter set is responsible for the correct color filtering of the pictures taken. To get to the filter set, remove the electrowind tape and remove the screws holding the lens filter set in place.

Remove the screws from the bottom of the camera using the tri-wing screwdriver.
  • Remove the screws from the bottom of the camera using the tri-wing screwdriver.

    • Three 5.4 mm tri-head screws.

Adicionar comentário

Remove screws from charger side of camera using the Phillips 00 screwdriver.
  • Remove screws from charger side of camera using the Phillips 00 screwdriver.

    • Two 3.3 mm Phillips #00 screws.

Adicionar comentário

  • Remove screws from wrist-strap side of camera using the Phillips 00 screwdriver.

    • Two 3.3 mm Phillips #00 screws.

Adicionar comentário

  • Separate the front and back casing using the spudger.

  • Gently pull apart the two casings.

  • Pull the back casing away from the camera.

Adicionar comentário

  • Remove electrowind strip from font cover.

    • The front cover does not have to be separated from the device for this step or the next ones.

Adicionar comentário

  • Remove lens data cable by gently pulling it out.

Adicionar comentário

  • Remove lens filter.

    • There are multiple square pieces, so be sure to remove them all.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Sarah Looper

Member since: 11-03-2013

76 reputação

7 Guides authored

Equipe

Clemson, Team 13-4, Benson Spring 2013 Membro de Clemson, Team 13-4, Benson Spring 2013

CLEM-BENSON-S13S13G4

2 Membros

8 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 10

Todo: 541