Conserte seus objetos Comunidade Loja

Fujifilm FinePix S8200 Selector Replacement

Introdução

The Selector is an important part of the camera because it controls the LCD screen. To replace it, follow the below steps.

O que você precisa

  1. Fujifilm FinePix S8200 Selector Replacement, Batteries: passo 1, imagem 1 %32

    • Turn the camera upside down so you can access the battery chamber.

    • Make sure that the camera is powered off before opening the battery chamber. Not doing so could damage your memory card.

    Editar

  2. Fujifilm FinePix S8200 Selector Replacement: passo 2, imagem 1 %32

    • Push the battery chamber latch in the direction of the front of the camera. Keeping tension on the latch, slide the battery chamber cover toward the outside of the camera, opening the battery chamber.

    Editar

  3. Fujifilm FinePix S8200 Selector Replacement: passo 3, imagem 1 %32

    • With the battery chamber open, remove the old batteries.

    • When replacing the batteries, remember that the battery orientation is shown by the + and - marks. Each mark indicates which side of the battery faces up in the chamber.

    Editar

  5. Fujifilm FinePix S8200 Selector Replacement, Rear Housing Cover: passo 4, imagem 1 %32 Fujifilm FinePix S8200 Selector Replacement, Rear Housing Cover: passo 4, imagem 2 %32 Fujifilm FinePix S8200 Selector Replacement, Rear Housing Cover: passo 4, imagem 3 %32

    • Remove the 4mm JIS #00 screws from the sides and bottom of the camera.

    Editar

  6. Fujifilm FinePix S8200 Selector Replacement: passo 5, imagem 1 %32 Fujifilm FinePix S8200 Selector Replacement: passo 5, imagem 2 %32 Fujifilm FinePix S8200 Selector Replacement: passo 5, imagem 3 %32

    • Carefully pry away the rear housing cover with the plastic opening tool.

    Editar

  7. Fujifilm FinePix S8200 Selector Replacement: passo 6, imagem 1 %32

    • Remove the rear housing cover by carefully pulling it away from the camera.

    Editar

  8. Fujifilm FinePix S8200 Selector Replacement, Removing Selection Button: passo 7, imagem 1 %32

    • To Replace the Selection button, carefully pull the button until the button has been fully detached.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Autor(a)

com 2 outros contribuidores

Ugent Dailey

Membro desde: 01/20/15

119 Reputação

Autoria de 1 guia

Emblemas: 5

+2 outros emblemas

Equipe

USF Tampa, Team 7-1, Remmell Winter 2015 Membro de USF Tampa, Team 7-1, Remmell Winter 2015

USFT-REMMELL-W15S7G1

Membros da 4

Autoria de 9 guias

Um comentário

preciso dessa peça.. aonde consigo encontrar para comprar? email: smchous@hotmail.com

smchous - Responder

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 4

Duração total: 1,100