Peças

Não são necessárias peças.

  1. Make sure that your vacuum is unplugged from a power source.
    • Make sure that your vacuum is unplugged from a power source.

    • Press the black button just below the handle and extend the pole fully.

    Adicionar comentário

  2. Press the black separator switch to separate the top and bottom halves of the vacuum.
    • Press the black separator switch to separate the top and bottom halves of the vacuum.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use a #2 Phillips head screwdriver to remove six 13.9mm screws from the side of the motor housing (top half) as shown.

    • Remove two 14.1mm screws from the front face of the housing. You are now all set to open the housing.

      • Keep a watchful eye on the two screws from the front face. These two have additional collars to their necks and will not fit in any of the other holes, yet no other screw will fit in their spots without the collar.

    Adicionar comentário

    • Pull out the button and the spring attached to it.

    • Swap the old spring with a new one.

    Adicionar comentário

    • Insert the new spring and button back into the right slot as shown in the picture.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Nikhila Vijaybhaskar

Member since: 24-09-2013

224 reputação

2 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Todo: 193