Conserte seus objetos Comunidade Loja

Ecovacs Deebot 900 Front Bumper Replacement

Introdução

The front bumper of the Ecovacs Deebot 900 is used to sense obstacles in its path. A malfunctioning front bumper can cause the Deebot to move in a circular fashion. Use this guide to remove or replace the front bumper on your Ecovacs 900 Deebot.

O que você precisa

  1. Ecovacs Deebot 900 Front Bumper Replacement, Battery: passo 1, imagem 1 %32

    • Remove all the brushes from the Deebot.

    Editar

  2. Ecovacs Deebot 900 Front Bumper Replacement: passo 2, imagem 1 %32

    • Using a Phillips #0 screwdriver, remove the two 12.25 mm screws holding the battery cover in place.​

    Editar

  3. Ecovacs Deebot 900 Front Bumper Replacement: passo 3, imagem 1 %32

    • Remove the battery cover.

    Editar

  5. Ecovacs Deebot 900 Front Bumper Replacement: passo 4, imagem 1 %32

    • Using the two white straps on the sides of the battery, gently remove the battery. ​

    • Be careful not to rip out the battery cable.

    Editar

  6. Ecovacs Deebot 900 Front Bumper Replacement: passo 5, imagem 1 %32

    • Carefully disconnect the battery cable by pulling near the connector at the bottom of the battery compartment.

    Editar

  7. Ecovacs Deebot 900 Front Bumper Replacement, Front Bumper: passo 6, imagem 1 %32 Ecovacs Deebot 900 Front Bumper Replacement, Front Bumper: passo 6, imagem 2 %32

    • Using a Phillips #00 screwdriver, remove the eight screws on the bottom edge of the bumper. ​

    Editar

  8. Ecovacs Deebot 900 Front Bumper Replacement: passo 7, imagem 1 %32

    • Remove the black strip on the bottom of the bumper.

    Editar

  9. Ecovacs Deebot 900 Front Bumper Replacement: passo 8, imagem 1 %32 Ecovacs Deebot 900 Front Bumper Replacement: passo 8, imagem 2 %32

    • Carefully lift up the bumper untill it pops out of place.​

    Editar

  10. Ecovacs Deebot 900 Front Bumper Replacement: passo 9, imagem 1 %32 Ecovacs Deebot 900 Front Bumper Replacement: passo 9, imagem 2 %32

    • Disconnect the two cables connecting the bumper to the body of the Deebot.

    • Remove the front bumper from the device.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Um comentário

Where may I buy the front bumper assembly? I'm trying to replace one for a deebot 901 but the mfg tells me they don't see the part directly.

Chris Khacherian - Responder

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 11

Últimos 7 dias: 58

Últimos 30 dias: 207

Duração total: 9,748