DualShock 2 Wireless Controller Analog Stick Replacement

Escrito Por: Roger Campbell (e 3 outros contribuidores)

Comentários: 0
Favoritos: 1
Execuções: 6

DualShock 2 Wireless Controller Analog Stick Replacement

Dificuldade

Moderado

Passos

Tempo necessário

10 minutos

Introdução

Often, through expected usage, an analog stick may become dislodged or misaligned on the DualShock 2 Wireless controller. This guide will show how to remove the faulty stick and realign it.

Ferramentas

Phillips #0 Screwdriver

$5.49

Comprar
iFixit Opening Tool

$1.99

Comprar

Peças

Nenhum componente especificado.

Passo 1 Analog Stick

Remove the battery cover by pressing down on the release tab.

Remove the battery cover by pressing down on the release tab.
Remove the batteries.
It may be useful to use a small object to prop the controller during this fix.
For your safety and for the safety of the device, never work on the controller while it is still powered.

Editar

Passo 2

Remove the six 7.8 mm anchoring screws from the back casing of the controller using a Phillips #0 screwdriver.

Remove the six 7.8 mm anchoring screws from the back casing of the controller using a Phillips #0 screwdriver.

Editar

Passo 3

Pull apart the outer casing by hand, or by using a plastic opening tool, from the bottom of the controller.

Be mindful not to sever the connection between the battery pack attached to the back casing and the internal board

Pull apart the outer casing by hand, or by using a plastic opening tool, from the bottom of the controller.
Be mindful not to sever the connection between the battery pack attached to the back casing and the internal board

Editar

Passo 4

Remove the two 6.1 mm screws holding the internal analog stick board and the front of the controller together.

Remove the two 6.1 mm screws holding the internal analog stick board and the front of the controller together.

Editar

Passo 5

Lift the analog stick board away from the front of the controller.

Remove the detached or loose analog stick for realignment.

Lift the analog stick board away from the front of the controller.
Remove the detached or loose analog stick for realignment.

Editar

Passo 6

Realign the analog stick by pushing the removed stick back into its chassis with focus on pushing it in at the new, desired resting angle. You should feel or hear a small click if done correctly.

Realign the analog stick by pushing the removed stick back into its chassis with focus on pushing it in at the new, desired resting angle. You should feel or hear a small click if done correctly.
The stick may not immediately click into place under the pressure. Instead of pushing harder, try rotating the stick 90 degrees and pushing down again.

Editar