Conserte seus objetos Comunidade Loja

Drill Master Heat Gun Motor Replacement

Introdução

The motor inside the barrel of the gun powers the fan. Use this guide to replace the motor.

O que você precisa

  1. Drill Master Heat Gun Motor Replacement, Motor: passo 1, imagem 1 %32

    • Be sure the heat gun is unplugged before starting this process.

    • Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.

    • You will need a screwdriver extension.

    Editar

  2. Drill Master Heat Gun Motor Replacement: passo 2, imagem 1 %32

    • Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.

    • Don't try to open the casing just yet.

    Editar

  3. Drill Master Heat Gun Motor Replacement: passo 3, imagem 1 %32 Drill Master Heat Gun Motor Replacement: passo 3, imagem 2 %32 Drill Master Heat Gun Motor Replacement: passo 3, imagem 3 %32

    • Remove the barrel casing on either end by twisting and pulling each side off.

    Editar

  4. Drill Master Heat Gun Motor Replacement: passo 4, imagem 1 %32

    • Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.

    Editar

  6. Drill Master Heat Gun Motor Replacement: passo 5, imagem 1 %32

    • Remove the metal casing and fan cover from the fan unit.

    Editar

  7. Drill Master Heat Gun Motor Replacement: passo 6, imagem 1 %32

    • Bend the metal prongs backward that connect the fan motor to the plastic cap.

    • Bending the brackets too far back can cause the brackets to break.

    Editar

  8. Drill Master Heat Gun Motor Replacement: passo 7, imagem 1 %32

    • Remove the plastic cap from the motor,

    • This will allow you to work only with the motor and fan.

    Editar

  9. Drill Master Heat Gun Motor Replacement: passo 8, imagem 1 %32

    • Remove the fan by pulling it from the motor rod.

    Editar

  10. Drill Master Heat Gun Motor Replacement: passo 9, imagem 1 %32

    • Remove the two 12mm screws from the plastic fan casing using PH#00

    Editar

  11. Drill Master Heat Gun Motor Replacement: passo 10, imagem 1 %32

    • Remove the plastic fan casing.

    Editar

  12. Drill Master Heat Gun Motor Replacement: passo 11, imagem 1 %32

    • Remove the metal casing from the motor and insert the new motor in its place.

    • You may have to tug a little.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Um comentário

Where can I find a new motor?

jstabler38 - Responder

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 1

Últimos 7 dias: 3

Últimos 30 dias: 11

Duração total: 1,446