Ir para o conteúdo principal

Drill Master Heat Gun Fan Replacement

O que você precisa

  1. Drill Master Heat Gun Fan Replacement, Fan: passo 1, imagem 1 %32
    • Be sure the heat gun is unplugged before starting this process.

    • Remove the seven 14mm screws from the side of the drill using the PH#0 screwdriver.

    • You will need a screwdriver extension.

  2. Drill Master Heat Gun Fan Replacement: passo 2, imagem 1 %32
    • Remove the 8mm screw from underside of barrel using the PH#0 screwdriver.

    • Don't try to open the casing just yet.

  3. Drill Master Heat Gun Fan Replacement: passo 3, imagem 1 %32 Drill Master Heat Gun Fan Replacement: passo 3, imagem 2 %32 Drill Master Heat Gun Fan Replacement: passo 3, imagem 3 %32
    • Remove the barrel casing on either end by twisting and pulling each side off.

  4. Drill Master Heat Gun Fan Replacement: passo 4, imagem 1 %32
    • Remove the top casing to reveal inside of drill. You might have to tug a little harder for this one.

  5. Drill Master Heat Gun Fan Replacement: passo 5, imagem 1 %32
    • Remove the metal casing and fan cover from the fan unit.

  6. Drill Master Heat Gun Fan Replacement: passo 6, imagem 1 %32
    • Bend the metal prongs backward that connect the fan motor to the plastic cap.

    • Bending the brackets too far back can cause the brackets to break.

  7. Drill Master Heat Gun Fan Replacement: passo 7, imagem 1 %32
    • Remove the plastic cap from the motor,

    • This will allow you to work only with the motor and fan.

  8. Drill Master Heat Gun Fan Replacement: passo 8, imagem 1 %32
    • Remove the fan by pulling it from the motor rod and replace.

Conclusão

To reassemble your device, follow these instructions in reverse order.

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 2

Últimos 7 dias: 6

Últimos 30 dias: 21

Duração total: 2,423