Ir para o conteúdo principal

Dremel 4000 Back Case Replacement

Pré-requisito somente
Este guia destina-se apenas a ser usado como pré-requisito para outros guias. É incompleto por si só.

O que você precisa

  1. Dremel 4000 Back Case Replacement, Back Case: passo 1, imagem 1 %32 Dremel 4000 Back Case Replacement, Back Case: passo 1, imagem 2 %32
    • Start by removing the housing cap by unscrewing it.

    • Next, unscrew the now exposed collet nut while holding down the shaft lock button.

    • To remove the collet nut, you may need to use the small open-end wrench provided with the Dremel.

  2. Dremel 4000 Back Case Replacement: passo 2, imagem 1 %32
    • Using your hands, carefully remove hanger from casing.

  3. Dremel 4000 Back Case Replacement: passo 3, imagem 1 %32 Dremel 4000 Back Case Replacement: passo 3, imagem 2 %32
    • Remove the brush caps (one on each side) by using a flathead screwdriver bit.

    • The brush caps are spring loaded.

  4. Dremel 4000 Back Case Replacement: passo 4, imagem 1 %32
    • Using the Torx 15 screwdriver tip, remove the 5 screws (12.5 mm) that hold the casing together.

  5. Dremel 4000 Back Case Replacement: passo 5, imagem 1 %32
    • Use a plastic opening tool to gently wedge apart the hard plastic threads.

  6. Dremel 4000 Back Case Replacement: passo 6, imagem 1 %32
    • Use your hands to carefully remove the back casing so that none of the components fall out.

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas executaram este guia.

John Cobb

Membro desde: 01/20/16

1.689 Reputação

Autoria de 4 guias

Equipe

USF Tampa, Team 15-4, Remmell Spring 2016 Membro de USF Tampa, Team 15-4, Remmell Spring 2016

USFT-REMMELL-S16S15G4

Membros da 4

Autoria de 13 guias

0 comentários

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 1

Últimos 30 dias: 8

Duração total: 1,657