Peças

Não são necessárias peças.

  1. Using the Phillips #0 in the bit driver, carefully loosen and remove the single  5mm screw.
    • Using the Phillips #0 in the bit driver, carefully loosen and remove the single 5mm screw.

    • With the retaining screw removed, lift the panel upwards to separate it from the netbook.

    Adicionar comentário

  2. To replace the panel, do step 1 in reverse:
    • To replace the panel, do step 1 in reverse:

      • Align the panel slots in the appropriate grooves and set in place.

      • With the bit driver, replace the screw to secure the RAM panel.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Using the bit driver and the Phillips bit, remove both of the panel's retaining screws.

    • With the screws removed, lift the panel in the designated direction, as depicted in photo, for removal.

    • The hard drive is located beneath this cover and is now accessible.

    Adicionar comentário

    • To replace the hard drive panel, do step 3 in reverse:

      • Place the panel back in its original position and press down.

      • If the hard drive was removed or replaced during this process, improper installation may prevent the hard drive panel from sitting in the slots properly.

      • With the bit driver and Phillips bit, replace the two retaining screws to secure the cover plate in place.

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Mason McCaskill

Member since: 18-10-2013

943 reputação

9 Guides authored

Equipe

Clemson, Team 14-2, Benson Fall 2013 Membro de Clemson, Team 14-2, Benson Fall 2013

CLEM-BENSON-F13S14G2

3 Membros

9 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 7

Todo: 598