Remove the four rubber screw covers from encircled locations.
  • Remove the four rubber screw covers from encircled locations.

  • Using a #0 tri wing screwdriver, remove the screws previously hidden below the rubber covers.

  • If you have difficulties finding this screwdriver, it is commonly sold as a Nintendo Gameboy/Wii screwdriver.

Adicionar comentário

Pry the case open using iPhone tool (as shown), fingernails, small flathead screwdriver, etc.
  • Pry the case open using iPhone tool (as shown), fingernails, small flathead screwdriver, etc.

  • Be mindful of location and magnitude of applied force, so as not to damage the case.

Adicionar comentário

Unlock the minor LCD connector by applying bilateral pressure with tweezers, as shown.
  • Unlock the minor LCD connector by applying bilateral pressure with tweezers, as shown.

Adicionar comentário

Use fingernails to pry off minor LCD mount, as shown.
  • Use fingernails to pry off minor LCD mount, as shown.

  • Remove the minor LCD

Adicionar comentário

Unlock the LCD main board connectors shown in red boxes on the picture .
  • Unlock the LCD main board connectors shown in red boxes on the picture .

  • Use tweezers as necessary.

Adicionar comentário

Place finger nails on the connector tab as shown.
  • Place finger nails on the connector tab as shown.

  • Lift the connector tab up.

Adicionar comentário

Pull/pivot the LCD main board as shown in order to remove.
  • Pull/pivot the LCD main board as shown in order to remove.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Van

Member since: 24-06-2010

7 reputação

16 Guides authored

Equipe

Cal Poly, Team 2-10, Johann Summer 2010 Membro de Cal Poly, Team 2-10, Johann Summer 2010

CPSU-JOHANN-R10S2G10

4 Membros

20 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 0

Todo: 1,729