Introdução

Separating the logic board from the face plate.

Peças

Não são necessárias peças.

Remove the two screws on both sides of the receiver. Keep these and the rest of the screws in a safe place.
  • Remove the two screws on both sides of the receiver. Keep these and the rest of the screws in a safe place.

Adicionar comentário

Remove the top screw on the back panel.
  • Remove the top screw on the back panel.

Adicionar comentário

  • Slide off the case to expose the internal components of the receiver.

Adicionar comentário

  • Unscrew the three screws on top of the face plate.

Adicionar comentário

  • Unscrew the one screw on the bottom of the front panel.

Adicionar comentário

  • Simultaneously push down on the head of the snap on each end of the device with your thumbs and push to seperate the face plate. This may take some force.

Adicionar comentário

  • On the inside middle of the face plate you will see two screws in the logic board. Unscrew these two screws.

Adicionar comentário

  • You will see the same snaps along the top of the logic board. Press the heads of the snaps down and pull the logic board out and up.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Ryan

Member since: 13-04-2010

86 reputação

3 Guides authored

Equipe

Cal Poly, Team 27-92, Amido Spring 2010 Membro de Cal Poly, Team 27-92, Amido Spring 2010

CPSU-AMIDO-S10S27G92

4 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 1

Todo: 2,151