Conserte seus objetos Comunidade Loja

Disassembling Marshall MS-2 Partner Circuit Board

O que você precisa

  1. Disassembling Marshall MS-2 Partner Circuit Board, Disassembling Marshall MS-2 Micro Amp Case Disassembly: passo 1, imagem 1 %32

    • First be sure to turn the power switch to the off position.

    • Do this by turning the leftmost knob counter-clockwise as until the line points to "off."

    Editar

    To turn the device off, turn the rightmost knob counterclockwise, not the leftmost one (which controls the volume).

    Célestin Taramarcaz - Responder

  2. Disassembling Marshall MS-2 Partner Circuit Board: passo 2, imagem 1 %32 Disassembling Marshall MS-2 Partner Circuit Board: passo 2, imagem 2 %32 Disassembling Marshall MS-2 Partner Circuit Board: passo 2, imagem 3 %32

    • Now remove the battery.

    • On the back of the device locate the battery cover.

    • Remove it by pushing down on the clip.

    • Then pull the piece of fabric until the battery comes out.

    Editar

  3. Disassembling Marshall MS-2 Partner Circuit Board: passo 3, imagem 1 %32 Disassembling Marshall MS-2 Partner Circuit Board: passo 3, imagem 2 %32

    • Use the long, skinny phillips head screwdriver to remove the 4 7/16" screws on the back of the device in the four corners.

    • Once unscrewed, do not try to take each screw out. Move to next step once all screwed have been unscrewed.

    Editar

  5. Disassembling Marshall MS-2 Partner Circuit Board: passo 4, imagem 1 %32

    • Now pull the back panel off and place it down as shown. Pull the panel straight up so you do not lose the screws.

    Editar

  6. Disassembling Marshall MS-2 Partner Circuit Board, Partner Circuit Board: passo 5, imagem 1 %32 Disassembling Marshall MS-2 Partner Circuit Board, Partner Circuit Board: passo 5, imagem 2 %32

    • Use a 9/16" socket to remove the nut around the headphone jack. Be careful to not lose the washer.

    Editar

  7. Disassembling Marshall MS-2 Partner Circuit Board: passo 6, imagem 1 %32

    • Remove the 7/16" phillips head screw.

    Editar

  8. Disassembling Marshall MS-2 Partner Circuit Board: passo 7, imagem 1 %32

    • Grab the headphone jack from inside the case and pull it toward the speaker until you can fully remove it from the device.

    Editar
Conclusão

To reassemble your device, follow these instructions in reverse order.

3 outras pessoas executaram este guia.

Autor(a)

com 3 outros contribuidores

MacKinley

Membro desde: 10/22/13

811 Reputação

Autoria de 5 guias

Emblemas: 10

+7 outros emblemas

Equipe

University of Maryland, Team 1-1, Shastany Fall 2013 Membro de University of Maryland, Team 1-1, Shastany Fall 2013

UMD-SHASTANY-F13S1G1

Membros da 3

Autoria de 5 guias

Um comentário

There Is a toroidal transformer inside ?

Jack redmond - Responder

Adicione um comentário

Exibir estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 0

Últimos 30 dias: 4

Duração total: 1,850