Find the battery and the battery tabs located on the bottom of the Compaq Mini.
  • Find the battery and the battery tabs located on the bottom of the Compaq Mini.

Adicionar comentário

Push the tabs inward and slide the battery out.
  • Push the tabs inward and slide the battery out.

Adicionar comentário

  • Find and remove the two screws on the bottom of your Compaq Mini covering the memory compartment.

    • Note that the screws are attached to the panel.

Adicionar comentário

  • Push out side tabs.

Adicionar comentário

  • Remove the rubber pads located on the corners of your Compaq Mini.

  • There may be junk underneath it. This is residue left from the glue that held on the rubber pad. Just scrape it away to find the screw.

Adicionar comentário

  • Unscrew all the corner screws. There are four total, one under each rubber pad.

Adicionar comentário

  • Unscrew the screw for the bottom case located in the RAM compartment.

Falta um passo, pois nos modelos COMPAQ MINI 110, existe um parafuso que segura o teclado, que se encontra bem escondido dentro da cavidade que encaixa a bateria.

Amilcar Correia - Responder

  • Remove the three screws in the silver tabs at the back of the keyboard. The red circles show where they are located at the back of the base under the screen.

3 screws in red circles are actually on metal tabs in the battery compartment, 1 deeper than the other 2. There is a keyboard symbol for each of the 3 screws.

Step 8B: Lift out keyboard by pushing upwards on the 2 accessible metal tabs. This is the most difficult step. Lack of Quality Control during assembly may prevent the kevboard from lifting out without breaking!!

John - Responder

This step may be performed after battery removal. Use care when removing ribbon cable: the white clips holding the black plastic "keeper" are fragile. Reassembly possible without white clips; however, jostling may cause the ribbon to come free.

Jason L - Responder

  • Remove the three screws.

Adicionar comentário

  • Pull up on the tab.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

10 outras pessoas concluíram este guia.

alea

Member since: 06-10-2010

1.290 reputação

14 Guides authored

Equipe

Cal Poly, Team 22-2, Maness Fall 2010 Membro de Cal Poly, Team 22-2, Maness Fall 2010

CPSU-MANESS-F10S22G2

6 Membros

20 Guides authored

still cannot remove back of my compacq mini. i have taken all screws out as told but back refuses to part.

madudman - Responder

still cannot remove back of my compact after removing all screws. are ther any more hidden clips ? mike

madudman - Responder

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 2

Últimos 7 dias: 21

Últimos 30 dias: 98

Todo: 32,580