Introdução

This guide will instruct the user on how to remove the front cover of the Canon A590 IS.

Peças

Não são necessárias peças.

The battery hatch is on the bottom of the camera. CAUTION: Locate the switch to open the hatch and push gently toward the front of the camera. Too much force can break the hatch.
    • The battery hatch is on the bottom of the camera.

    • CAUTION: Locate the switch to open the hatch and push gently toward the front of the camera. Too much force can break the hatch.

    • While the switch is pushed forward, pull the cover away from the camera.

Can the hatch be replaced. The piece that holds the hatch is broken.

alisonbforman46 - Responder

This camera requires AA batteries. To remove batteries, simply allow them to fall out of the camera.
    • This camera requires AA batteries. To remove batteries, simply allow them to fall out of the camera.

    • The clock battery cover is shown here in the purple circle. Use a fingernail to lift the battery out of the camera.

Adicionar comentário

When replacing the AA batteries, verify they are oriented correctly by following the (+) and (-) signs on the camera.
  • When replacing the AA batteries, verify they are oriented correctly by following the (+) and (-) signs on the camera.

Adicionar comentário

Remove the screw located under the rubber flap on the left side of the camera using a magnetic screwdriver.
  • Remove the screw located under the rubber flap on the left side of the camera using a magnetic screwdriver.

Adicionar comentário

Remove the two screws located on the other side of the camera using a magnetic screwdriver
  • Remove the two screws located on the other side of the camera using a magnetic screwdriver

Adicionar comentário

Remove the three screws located at the bottom of the camera using a magnetic screwdriver.
  • Remove the three screws located at the bottom of the camera using a magnetic screwdriver.

Adicionar comentário

Open the battery cover.
  • Open the battery cover.

  • Using the iPod tool, push up gently around all edges of the camera.

Adicionar comentário

Press and hold down the button shown in the blue circle.
  • Press and hold down the button shown in the blue circle.

  • While pressing the button, rotate the lens cover in a counter-clockwise direction to remove it.

Adicionar comentário

Remove the front cover of the camera. This may require a bit of force.
  • Remove the front cover of the camera.

    • This may require a bit of force.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

4 outras pessoas concluíram este guia.

Zach

Member since: 11-10-2010

237 reputação

6 Guides authored

Equipe

Cal Poly, Team 9-19, Regan Fall 2010 Membro de Cal Poly, Team 9-19, Regan Fall 2010

CPSU-REGAN-F10S9G19

4 Membros

7 Guides authored

The photos do not show a camera strap, and the instructions don't mention it. Before starting disassembly, I advise removing the camera strap. It make it easier to remove and re-attach the back cover.

jwoconnor - Responder

A handy guide. I had an A590IS with a broken battery door latch on the camera body, and I managed to obtain a dead A590IS with a fully intact latch for free. So using this guide I swapped the body shells over! All fixed and working again!

brianinnes81 - Responder

l cannot get an answer to my question on why my Canon A590 will not power on.

burks817 - Responder

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 5

Últimos 30 dias: 22

Todo: 12,811