Introdução

This guide will show you how to disassemble the back and side panel of the printer.

Peças

Não são necessárias peças.

  1. Remove the following two Phillips screws: Two 7.85 mm Phillips #1 screws
    • Remove the following two Phillips screws:

    • Two 7.85 mm Phillips #1 screws

  2. Pull the back cover off by lifting up on the cover.
    • Pull the back cover off by lifting up on the cover.

    • You may need to pull firmly as it requires quite a bit of force.

  3. Open the front tray.
    • Open the front tray.

  4. Free shipping on all orders over US$100 or containing a Pro Tech Toolkit!

    Visite Nossa Loja
  5. Lift the scanner compartment.
    • Lift the scanner compartment.

  6. After opening up the scanner compartment, make sure the blue lever locks into place, keeping the compartment open.
    • After opening up the scanner compartment, make sure the blue lever locks into place, keeping the compartment open.

  7. Push the blue lever back while twisting it clockwise in order to remove the lever from its slot. After removing the lever, close the scanner compartment and the scanner cover.
    • Push the blue lever back while twisting it clockwise in order to remove the lever from its slot.

    • After removing the lever, close the scanner compartment and the scanner cover.

  8. Use the plastic opening tool to pry open the side cover. Use the plastic opening tool to pry open the side cover.
    • Use the plastic opening tool to pry open the side cover.

  9. Flip the printer so that you are facing the underside. Use the plastic opening tool to remove the corner of the side panel from the pin.
    • Flip the printer so that you are facing the underside.

    • Use the plastic opening tool to remove the corner of the side panel from the pin.

    • Plastic pin.

  10. Using the plastic opening tool, remove the side panel by loosening it from the bottom of the printer. Using the plastic opening tool, remove the side panel by loosening it from the bottom of the printer.
    • Using the plastic opening tool, remove the side panel by loosening it from the bottom of the printer.

Conclusão

To reassemble your device, follow these instructions in reverse order.

5 outras pessoas concluíram este guia.

Kevin Cole

Member since: 17-01-2013

98 reputação

Autoria de 1 guia

Equipe

Cal Poly, Team 19-41, Regan Winter 2013 Membro de Cal Poly, Team 19-41, Regan Winter 2013

CPSU-REGAN-W13S19G41

4 Membros

6 Guides authored

Visualizar Estatísticas:

Últimas 24 horas: 5

Últimos 7 dias: 31

Últimos 30 dias: 121

Todo: 13,754