Introdução

This guide describes the steps to opening the case.

Peças

Não são necessárias peças.

  1. Remove 2 screws from each side of the amplifier.
    • Remove 2 screws from each side of the amplifier.

  2. Remove 2 screws on rear of device. Slide top cover up and back from main case.
    • Remove 2 screws on rear of device. Slide top cover up and back from main case.

  3. Free shipping on all orders over US$100 or containing a Pro Tech Toolkit!

    Visite Nossa Loja
  4. Remove 3 screws on bottom of case. Remove 13 screws on rear panel.
    • Remove 3 screws on bottom of case.

    • Remove 13 screws on rear panel.

    • Do not move the rear panel too far, as the power cord is still connected.

  5. Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.
    • Using a pair of pliers, squeeze the retainer for the power cord as shown and pull it toward the external side the panel.

    • It may require some wiggling, but it should slip out of the hole and then off of the cord.

Conclusão

To reassemble your device, follow these instructions in reverse order.

3 outras pessoas concluíram este guia.

Colby

Member since: 15-04-2010

284 reputação

3 Guides authored

Equipe

Cal Poly, Team 28-36, Regan Spring 2010 Membro de Cal Poly, Team 28-36, Regan Spring 2010

CPSU-REGAN-S10S28G36

4 Membros

3 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 2

Últimos 30 dias: 4

Todo: 3,416