Introdução

This is the beginning process to remove or replace any functional component in the AirPort.

Peças

Não são necessárias peças.

Remove the three 5mm T7 Torx screws from the back panel.
  • Remove the three 5mm T7 Torx screws from the back panel.

Adicionar comentário

Remove one 5mm phillips screw located under the identification sticker.  You will need to remove the sticker or make a hole to get to the screw.
  • Remove one 5mm phillips screw located under the identification sticker. You will need to remove the sticker or make a hole to get to the screw.

Adicionar comentário

Separate the bottom and top casings.
  • Separate the bottom and top casings.

Adicionar comentário

Remove the metal case from the top case of the AirPort, there are no screws holding it on. Remove the four screws from the metal casing.
  • Remove the metal case from the top case of the AirPort, there are no screws holding it on.

  • Remove the four screws from the metal casing.

Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

2 outras pessoas concluíram este guia.

Michael Garcia

Member since: 12-10-2011

369 reputação

5 Guides authored

Equipe

Cal Poly, Team 17-15, Regan Fall 2011 Membro de Cal Poly, Team 17-15, Regan Fall 2011

CPSU-REGAN-F11S17G15

3 Membros

7 Guides authored

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 9

Últimos 30 dias: 25

Todo: 1,619