1. First: Eye Camera
    • First: Eye Camera

    • Remove initial frame (crack off)

    Adicionar comentário

  2. Remove 4 screws.
    • Remove 4 screws.

    Adicionar comentário

    • Remove cover to get to the PCB underneath

    Adicionar comentário

    • Remove two screws on the PCB.

    Adicionar comentário

    • Remove PCB from the base plastic piece.

    Adicionar comentário

    • Break base plastic piece. Cutters work well. Be careful not to snip the wire attached to the PCB.

    Adicionar comentário

    • Black mold (from 3D printer) piece attaches to the PCB with 4 screws.

    Adicionar comentário

    • Completed assembly of the eye camera.

    Adicionar comentário

    • Back of pupil camera is glued on. Remove with flat-head.

    Adicionar comentário

    • Remove the black frame on the front of the pupil camera.

    Adicionar comentário

    • Once frame is taken off the front, two screws need to be removed.

    Adicionar comentário

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • One screw removed from the back.

    Adicionar comentário

    • Front housing comes off once the screws are removed from the frame.

    • Twist out the silver microphone.

    Adicionar comentário

    • Pull off bottom stand until it breaks off.

    Adicionar comentário

    • Remove rubber/plastic piece from the bottom

    Adicionar comentário

    • Remove four screws from under the plastic tape (removed from last step).

    Adicionar comentário

    • Bottom pops off

    Adicionar comentário

    • Separate the metal frame from the plastic assembly.

    • Avoid the cables

    Adicionar comentário

    • Take out PCB from the plastic housing.

    Adicionar comentário

    • Remove the rest of the black plastic housing.

    Adicionar comentário

    • Black plastic housing removed

    Adicionar comentário

    • Continue removing the black plastic housing surrounding the inner PCB.

    Adicionar comentário

    • PCB removed from the black plastic housing.

    Adicionar comentário

    • Autofocus assembly.

    • Remove two screws from the bottom of the auto-focus PCB.

    Adicionar comentário

    • Unscrew the lens

    Adicionar comentário

    • Take out the IR filter by using a scalpel for pulling out the lens tape.

    Adicionar comentário

    • Comparison photos of completed autofocus assembly vs in-progress autofocus assembly

    Adicionar comentário

    • IR LEDs replaced by SMD LED

    • Soldering required here (at bottom of LED to remove).

    Adicionar comentário

    • SMD LED info: Thick black line is near the positive side of the LED

    • Dark side (dot) is positive side on LED.

    Adicionar comentário

    • Insert PCB into 3d-printed frame.

    Adicionar comentário

    • Completed assembly.

    • Sugru used for nose/head rest

    Adicionar comentário

Conclusão

To reassemble your device, follow these instructions in reverse order.

Uma outra pessoa concluiu este guia.

Silas

Member since: 25-11-2013

291 reputação

Autoria de 1 guia

Adicionar comentário

Visualizar Estatísticas:

Últimas 24 horas: 0

Últimos 7 dias: 4

Últimos 30 dias: 22

Todo: 553